Forum

I've had that happen to me more than once. Found out that if I need to have nothing connected to my C64/C128 except a single 1541 drive set as device ...

All of mine have the tape drive connector for power. Prefer it since I never connect anything to that port. i did have to add a longer wire for the on...

Short follow-up. I had a test BBS running for over 3 months now on a ZuluSCSI. No problems at all with it. Seems faster than the SCSI2SD when used wit...

I've been very happy with the SD2IEC from The Future Was 8-bit. www.thefuturewas8bit.com It's the only one I've ever used, so really don't have an...

One thing I immediately find very convenient. I can pop the SD card out of the ZuluSCSI, pop it into my laptop, and copy over both hd0.hda and hd1.hda...

Nice thing about the SCSI2SD, or even the ZuluSCSI. You can configure up to 7 drives (SCSI ID#0-6) on a single SD card. With the Lt. Kernal though, 2 ...

Here is contents of the modified zuluscsi.ini file I'm using. [SCSI]# Settings that apply to all devicesDebug = 0 # Same effect as DIPSW2, enabl...

It supports both Comlink and Net64. Comlink was a centralized network available only to Centipede BBS's. All nodes would call into a main hub. The ...

There are many pros and cons. For me, more of a challenge to get it working than anything. I attempted to setup Centipede with Net64. Ran into same pr...

I completely agree on the Ultimate-II+ for all the same reasons. Amazing everything that it can do. A very close send for me is the SD2IEC. I have ...

Finally, here is how I setup the LU's. LU number Starting Cylinder # # Cylinder Size SCSI Drive # 10 (DOS) 0 8 8 0 0 10 ...

I edited the Sysgen disk for 2 drives. Both are setup with same parameters. LTK Config 128 BIT 7="N" embedded controller 0 Ste...

For Device 2.  SCSI2SD-3.jpg